HIGHSIDER pro AKRON-RS license plate holder, SUZUKI GSX-R 1000 17-, without license plate light.

The HIGHSIDER pro AKRON-RS license plate holder adapts perfectly to the lines of your bike through its design.

The model-specific bracket of the HIGHSIDER pro AKRON-RS allows mounting on the original mounting points of your bike and thus a replacement without further drilling or cutting.
To prevent damage to cables, all sharp-edged feedthroughs are protected by a rubber membrane grommet.

The license plate is made of sheet steel and 2 mm thick. The precise cutting is done by laser. After edging still follows the weather-resistant black powder coating.
This ensures the optimal fit and durability.
Through the stepless adjustment you can bring the plate without drilling in the desired position. To keep the plate in this position, there is an additional locking screw.

The turn signal brackets of the HIGHSIDER pro AKRON-RS are adjustable in width and thus suitable for any type of accessory turn signals. This adjustment option allows you to adjust the position for your turn signals to the most diverse license plates. To allow mounting of the turn signals without separation from the wiring harness, the 8 mm holes are slotted to the side.

Also the position of the reflector you can adjust individually via a slider. Adaptation to the different designs of EU license plates is therefore no problem.

To screw the license plate securely and reduce vibration are included two rubber washers. Another rubber buffer supports the license plate on its underside.

Details:

• model-related bracket
• infinitely adjustable turn signal holder
• slotted turn signal holder for easy mounting without cable separation
• infinitely adjustable reflector, E-approved
• suitable for European license plates
• infinitely adjustable tilt angle
• additional screw for optimum position security
• easy fixation without further work steps (eg. Drilling)
• easy mounting of the license plate through slotted holes

Included in the scope of delivery of the HIGHSIDER pro AKRON-RS are:

• Model-related bracket with mounting parts
• HIGHSIDER pro AKRON-RS license plate mounting plate
• Adjustable turn signal brackets
• E-tested reflector with adjustable holder
• Mounting instructions

Notes:

• If side reflectors are mounted on your original license plate holder, they must be reattached in a suitable position or replaced with new ones.
• Special turn signal holders are optionally available for the original turn signals.
  
  Tip:
  Should you have found no model-specific license plate holder for your vehicle, the universal license plate holders from HIGHSIDER pro, which are available in many different designs, are certainly a good alternative.